Capillary Thermostat

Temperature of your spa with the passage of time should be replaced. The replacement is a simple solution, but you must remove the hot tub enclosure to replace. You will need owner's manual indicate that it is ready.

Things you need

Your textbook
Replacing the thermostat correctly
Screwdriver or a wrench to remove the door spa
wrench that fits the thermostat
Rubber sole shoes
Sandwich Baggi

Step 1 - Prepare

Unplug your spa and turn off the breaker to the control box. This way, you are doubly sure. Also wear shoes with rubber soles so that you are grounded. Remove the motor cover spa. Keep all your screws in a bag for later. Place the heater box and remove cover, placing the screws in the bag too, or a separate bag, if the screws are not all alike.

Step 2 - Remove the thermostat Bad

Locate the thermostat. Disconnect the wiring to the end connected to the engine. You should see a hairline into a live-in accommodation. It will use a nut holding the thermostat in place, your key to loosen it. Your thermostat should simply remove the right of the holder.

Step 3 - Install new thermostat

LiDE new thermostat in the bracket and tighten the nut of it. Deliver new son, where the elders were attached. Now, put the lid on the housing and tighten the screws. Flip the breaker on and and take in the spa. Turn the engine and let it run to check and see if it warms up. If so, put the door back on the spa, you're done!