Plasma Fires

I'm Havinga normal fire gas flued removed and it was recommended to buy a plasma gas vent-free gas fire.Am concern emerging from the combustion gas duing.

A catalytic converter with a combustion control system to ensure complete combustion of gases.

Initial operation will burn a little smoke, but only for a short period of use. After that, it should be clean combustion.

Make sure this unit is installed by a certified installer.

In addition, the room must have certain amount of ventilation.

Is it not those that look like photographs, small, compact (very nice too).

I thought they were sealed units, burns and internal condensation, but just using a little break by giving small quantities of gas, which would normally dissapate?

Perhaps wrongly, I am glad to hear the responses of others.



JJ.

I have a chimney least the type of wood burner that uses no gas at all, but instead of electricity only. The flames seem as real as any flame, but you can open the door and put his hand there and keep it there without burning. It seems quite natural, heat is generated from an electric water heater hidden beneath the wood stove. This stack of false papers, but the flame still seems as real as any. Could this perhaps what has been described to you? I saw your question and was just wondering. One as it solve all the worries about gas or carbon dioxide. I purchased mine at the real value of the equipment. PS. You can activate the flames without using the heater too.

Not sure of the burner of the specific you are considering. However, any gas burner will produce combustion gases and there is no combustion, and then they go into your room. As suggested in one of the other answers, a catalytic converter ensures that all gas is burned and burned completely so no thats carbon monoxide poison! carbon dioxide and water relatively harmless. As stated, you must have some room ventilation if carbon dioxide accumulates and eventually stifle both you and the fire! Since it is known fluless plasma ... it is possible that the high voltage discharge is used to help the burning (combustion) rather than a catalytic converter, the effect is always the same regardless of the fact. There is no way to burn gas and not have to waste gas on. But a very clean burner is possible and the products of combustion are not dangerous as long as you do not allow them to accumulate in the room.